Teknova Water Based Matt Varnish FM 543X – 200 kg
Advantages
• Teknova Water Based Matt Varnish
FM 543X have the desired properties (gloss, opacity, lubricity, etc.), as well
as the possibility to print without problems in the lacquer unit.
• Created to meet the needs of the
industry and generally experienced problems such as in box gluing, folding
cracks, scratches and completely eliminates the problems.
• Lit also provides a wide range
of motion to the users with its compliance with legal regulations (FDA24, SWISS
ORDINANCE).
Direction For Use
It is recommended to be used on
coated and many similar paper and cardboard surfaces. Metal sheets, plastics or
test before use on low porosity substrates such as thin films.
Suitability for uncoated papers,
boards and papers below 115 gsm may vary depending on the application.
Flat offset varnish unit (anilox or
roller lacquer systems)
Required drying conditions: IR and
Hot air circulation
Wet-on-dry (offline) printing for
conventional inks
• Mix well before use.
• Wet film weight is 3-6gsm for
most applications.
• For ideal results, inks with high
alkali resistance and no wax should be preferred. Production It is recommended
to test the ink compatibility before processing.
• Inappropriateness of the printing
surface and ink, insufficient drying or poor friction can cause resistance.
Therefore, check the suitability of the surface and the ink.
• Check the viscosity and adjust
with water if necessary.
• Recommended maximum stack
temperature = 36 °C.
• The best results for Bonding /
Foil / Lamination / UV Lacquer are a combination of many factors, this so
always take an initial acceptance test for a particular application. Full
curing (drying) of the product is at least 24 hours later.